7.1 WITHOUT REMOTE CONTROLLER
1.Open a hot water tap.
The setting temperature is preset at 70
If you need to change the setting temperature without remote controller, please adjust
the DIP switch, refer to diagram below.
●
The Temperature setting:
55℃
●
Only change the switches with dark squares.
●
DO NOT adjust other switches. If a DIP switch is incorrectly set, It will lead to a minimum
setting temperature.
2.Mix cold water with the
hot to get the correct
temperature water.
NOTE
ºC.
DIP switch
ON
SAB
1
2
3
4
ON SAB
60℃
1 2 3 4
3.Close the hot water tap.
ON SAB
70℃
1 2 3 4
18
DIP switch
ON SAB
1 2 3 4