Delta 70-200 Instruction Manual page 11

THE PLYWOOD BASE MUST BE
SECURED TO THE FLOOR OR SUPPORTING
SURFACE IF THERE IS ANY TENDENCY OF THE
DRILL PRESS TO VIBRATE, SLIDE OR WALK
DURING NORMAL OPERATION.
ASSEMBLING THE
DRILL PRESS
1. Assemble column (A) Fig. 2, to base (B) using four M
12 x 45mm long hex head screws (three of which are
shown at [C]). Loosen set screw in collar (D) and remove
D
collar (D) and raising rack (E).
E
2. Remove bolt (F) Fig. 3, and remove table (G) from
table bracket (H).
A
B
H
C
F
G
Fig. 2
Fig. 3
11