Displays, Icons And Cursors; Button Functions - GE Pro Elite 268-716-150-1248 Operation Manual

Displays, Icons and Cursors

Note: In normal operation and during programming,
only a few of the icons will actually be displayed.
1. Used to select and indicate the actual Day of the Week
setting.
2. This cursor is displayed when programming the Days
Override.
3. PM indicator displayed when setting Time of Day and
Time of Regeneration. Note: There is no AM indicator.
4. Indicates displayed value in minute increments.
5. Indicated kilograins or kilograms when estimated
capacity is diplayed.
6. Used to display "P", "H", and "C" parameter.
7. Indicates access into "H" Level IV History viewing.
8. Indicates access into "P" Level ll programming.
9. Used to display cycle position during regeneration.
Also indicates access into "C" Level III cycle
programming.
10. This cursor is displayed during Level l programming:
Time of Day, Regen Time, Day, Salt, etc.
11. When flashing, this indicates regeneration is to occur
at next Time of Regen. Appears as a solid icon during
regeneration.
12. When hourglass is flashing, this indicates that the
control is moving to a regeneration cycle. Appears as
a solid icon during a cancelled regeneration and the
control is cycling directly back to the home position.
13. Indicates the selected program setting has been
locked out. Lock settings are changed in Level II
programming.
14. Indicates double regeneration.
Figure 15
15. Normally off. Will glow red if salt brine is not reaching
the valve during recharge. Indicates out-of-salt
condition.
16. Maintenance display turns on if the months in service
exceed the value programmed in P11 "Service
Interval".
17. When Lbs/ft is displayed, the value for regenerant
3
amount entered is in pounds per cubic foot.
18. X100 multiplier for large values.
19. When "g/L" is displayed the valve is in grams per liter.

Button Functions

SET
DOWN
arrow
DOWN and UP Arrows: Used to scroll through settings or
change setting value.
SET: Used to enter a setting into memory or activate a
setting to be changed.
REGEN: Used to command the control to regenerate and
enable or disable lockout setting.
17
UP arrow
For Regeneration
Figure 16