Making Connections - Sony MEX-N5200BT Operating Instructions Manual

*1 Not supplied
*2 Speaker impedance: 4 Ω – 8 Ω × 4
*3 RCA pin cord (not supplied)
*4 Depending on the type of car, use an adaptor for
a wired remote control (not supplied). For details
on using the wired remote control, see "Using
the wired remote control" (page 38).
*5 Whether in use or not, route the microphone
input cord such that it does not interfere with
driving operations. Secure the cord with a clamp,
etc., if it is installed around your feet.
*6 Note for the antenna (aerial) connecting
(Argentine models only):
If your car antenna (aerial) is an ISO
(International Organization for Standardization)
type, use the supplied adaptor  to connect it.

Making connections

 To a common ground (earth) point
First connect the black ground (earth)
lead, then connect the yellow and red
power supply leads.
 To the +12 V power terminal which is
energized at all times
Be sure to first connect the black ground
(earth) lead to a common ground (earth)
point.
 To the +12 V power terminal which is
energized when the ignition switch is
set to the accessory position
If there is no accessory position, connect
to the +12 V power (battery) terminal
which is energized at all times.
Be sure to first connect the black ground
(earth) lead to a common ground (earth)
point.
 To the power antenna (aerial) control
lead or the power supply lead of the
antenna (aerial) booster
It is not necessary to connect this lead if
there is no power antenna (aerial) or
antenna (aerial) booster, or with a
manually-operated telescopic antenna
(aerial).
To AMP REMOTE IN of an optional
power amplifier
This connection is only for amplifiers and
a power antenna (aerial). Connecting any
other system may damage the unit.
36
GB
For MEX-N5200BT:
 To a car's illumination signal
Be sure to first connect the black ground
(earth) lead to a common ground (earth)
point.
For Argentine models:
If you have a power antenna (aerial) without
a relay box, connecting this unit with the
supplied power supply lead  may damage
the antenna (aerial).
 To the car's speaker connector
1
Rear speaker
(right)
2
3
Front speaker
(right)
4
5
Front speaker
(left)
6
7
Rear speaker
(left)
8
 To the car's power connector
continuous power
12
supply
power antenna (aerial)
13 /power amplifier
control (REM OUT)
switched power
15
supply
16 ground (earth)
 Purple
Purple/black

striped
 Gray
Gray/black

striped
 White
White/black

striped
 Green
Green/black

striped
Yellow
Blue/white
striped
Red
Black