Table of Contents
Advertisement
3. Click DMZ in the side menu to display the DMZ Settings screen.
4. Enter the following parameters.
Enable – Click this checkbox to enable DMZ on the network.
Static IP – Displays the static IP address.
Private IP – Enter the IP address of the computer to be placed in the DMZ. Be sure
that the address is not in the range of addresses delivered by the DHCP server if
enabled. After placing the computer in the DMZ, all ports on the computer are open to
the Internet and not protected.
5. Click Apply at the bottom of the screen.
Note: To remove the computer from the DMZ, delete the entries and uncheck the Enable
DMZ checkbox.
Utilities – Viewing Network System Information
You can view status and system information for the network on the System Information
screen.
Perform the following steps to view system status information.
1. Access and log into the configuration interface.
2. Click the Utilities tab.
3. Click System Information in the side menu to display the System Information
screen.
Note: Refer to
information parameters.
Utilities – Restarting the Wireless Router
It may be necessary to restart (reboot) the Wireless Router if it begins working improperly.
Restarting the Wireless Router will not delete any of the configuration settings.
Perform the following steps to restart the Wireless Router.
1. Access and log into the configuration interface.
2. Click the Utilities tab.
3. Click Restart Router in the side menu to display the Restart Router screen.
4. Click the Restart Router button to restart the Wireless Router.
Release 33 STANDARD 1.5 February 2015
System Information
(page 51) for an explanation of the various status
Chapter 6: Advanced Configuration Options
TR3300-AC 802.11ac Wireless Router User Guide 27
Advertisement
Table of Contents
