Harbor Freight Tools Vulcan Migmax 215 Owner's Manual & Safety Instructions page 9

6. 10-12 Pound Wire Spool Installation:
Remove the Wingnut and Spacer. If
replacing a Spool, remove the old Spool
and all remaining wire from the liners.
7. Place the Spool Adapter over the Spool Spindle
and against the Spool Brake Pad as illustrated.
8. Place the new Wire Spool over the Adapter and
line up pin on Adapter with hole in Spool.
To prevent wire feed problems, set the
Spool so that it will unwind clockwise.
9. Replace the Spacer over the Spool Spindle
and secure Spool in place with the Wingnut.
Notice: If Wire Spool can spin freely, Wingnut
is too loose. This will cause the welding
wire to unravel and unspool which can
cause tangling and feeding problems.
10. Screw the Spool Knob into the Spool Adapter.
11. DCEN Direct Current Electrode Negative
Wire Setup for Flux-Cored (gasless) welding:
Remove the two Wingnuts securing the cables.
Connect the Black Ground Cable to the positive (+)
Terminal using the Wingnut.
Connect the Red Cable to the negative (
Terminal using the other Wingnut.
Make sure the Cable connectors
sit flush in the grooves.
Item 63617
unwind
in this
direction
–
)
For technical questions, please call 1-888-380-0318.
10-12 lb
Spool
Adapter
10-12 lb Spool Loading
Wire
must
Flux-Cored (Gasless) Polarity Setup
Spool Knob
Wingnut
Spacer
10-12 lb
Wire Spool
Spool Spindle
Spool
Brake Pad
Welder
Wall
DCEN
Page 9