Harbor Freight Tools Vulcan Migmax 215 Owner's Manual & Safety Instructions page 38

Grounding
TO PREVENT ELECTRIC SHOCK AND DEATH
FROM INCORRECT GROUNDING WIRE CONNECTION:
Check with a qualified electrician if you are in doubt as to whether the outlet is
properly grounded.
Do not use the Welder if the power cord or plug is damaged. If damaged, have it repaired by a service
facility before use. If the plug will not fit the outlet, have a proper outlet installed by a qualified electrician,
do not use adapter plugs.
1. The green wire inside the cord is connected to
the grounding system in the Welder. The green
wire in the cord must be the only wire connected
to the Welder's grounding system and must
never be attached to an electrically "live" terminal.
Never leave the grounding wire disconnected
or modify the Power Cord Plug in any way.
Extension Cords
Do not use an extension cord on this Welder.
Replacement Cords
1. Use only one of the supplied power cords for
this Welder or an identical replacement cord.
2. Do not install a thinner or longer
cord on this Welder.
Page 6 For technical questions, please call 1-888-380-0318.
2. Make sure the tool is connected to an outlet having
the same configuration as the plug. If the tool must
be reconnected for use on a different type of electric
circuit, the reconnection should be made by qualified
service personnel; and after reconnection, the tool
should comply with all local codes and ordinances.
3. Do not patch cords of any length
together for this item. Patches may allow
moisture to penetrate the insulation,
resulting in electric shock.
Item 63617