Harbor Freight Tools Vulcan Migmax 215 Owner's Manual & Safety Instructions page 45

20. Make sure the welding wire is resting in the groove
of the Feed Roller, then push the wire Idler Arm
down, and swing the Feed Tensioner up to latch it
across the tip of the arm.
After the wire is held by the Tensioner,
you may release it.
Note: The tension should be 3 – 5 for solid wire and
2 – 3 for flux-cored wire. Too much force on flux-cored
wire will crush it and may cause feeding issues.
21. Pull the Nozzle to remove it.
22. Unscrew the Contact Tip
counterclockwise and remove.
23. Lay the MIG Gun Cable out in a straight line so
that the welding wire moves through it easily.
Leave the cover open, so that the feed
mechanism can be observed.
Stainless steel wire is less flexible than other welding wire. Therefore, it is
more difficult to feed through the liner and gun. It is especially important
to keep the gun cable straight while feeding stainless steel wire.
24. Plug either 120 V AC or 240 V AC Power
Cord into Power Input Socket.
Note: Plug will only fit one way.
Item 63617
IMPORTANT
1.
2.
3.
For technical questions, please call 1-888-380-0318.
Idler Arm
Nozzle
Contact
Tip
Power
Power Input
Input
Gas Inlet
Reset
Feed Tensioner
MIG Gun
Page 13