Phone Programming - Rath Command Center Installation & Operation Manual

2. Dial 1002 followed by the appropriate time zone code:
Eastern 111
Central 112
Mountain 113
Pacific 114
3. Touch the Check Mark Button in the middle of the phone
4. Exit programming by dialing 00 followed by the Check Mark Button
Programming Month-Day-Year
1. Enter Programming Mode:
a. Dial 1#91
b. Enter Password: 7284
2. Dial 1001 followed by the date
Example: 1001 15022011 (February 15, 2011)
3. Touch the Check Mark Button
4. Exit programming by dialing 00 followed by the Check Mark Button
Programming Time
1. Enter Programming Mode:
a. Dial 1#91
b. Enter Password: 7284
2. Dial 1003 followed by the time
Example: 1003 143000 (2:30 p.m.)
3. Touch the Check Mark Button
4. Exit programming by dialing 00 followed by the Check Mark Button
Programming External Phone Number
Note: If phone is dialing Command Center only, skip this step.
1. Press speaker phone button
a. Dial 1, 3, 4
b. Dial 9, then external phone number
c. Press # , *
Emergency Phone Programming
Connect the Phone to an active Port on Distribution Module and follow the instructions below:
Emergency Phone Calls the Command Center:
1. For the Emergency Phone to call the Command Center, it must be programmed to dial 0
2. Follow the directions that came with the Emergency Phone to program Memory Location 1 to dial 0
Emergency Phone Calls a Number Outside of the Building:
1. For the Emergency Phone to call a number outside the building, it must be programmed to first
dial 3931
2. Follow the directions that came with the Emergency Phone to program Memory Location 1 to dial 3931
Emergency Phone Calls the Command Center First then a Number Outside of the Building:
1. The Emergency Phone can be programmed to call the Command Center first and if that call is not
answered, call an outside number
2. Follow the directions that came with the Emergency Phone to program Memory Location 1 to dial 3931
Page 3