Chicco Fit 2 Instructions page 4

Hide thumbs Also See for Fit 2:

Enlarged version

Fold the 2 plastic tabs under the edge of the Carrier

shell.

Locate the pocket on the back of the Head Rest fabric,

slide the bottom edge of the Head Rest Back Plate into the

pocket.

Lay Harness Straps over the seat back to make

sure the Harness Straps are NOT twisted and oriented as

shown. With the Head Rest in the lowest position, thread

Harness Strap ends into the openings on the Head Rest

Back Plate.

Attach BOTH Harness Straps to the Splitter Plate.

WARNING - Make sure Harness Straps are not twisted and

both Harness Straps are securely attached to splitter plate.

Flip the Carrier over and push both fingers of the

plastic tab into the correct slots, as shown.

WARNING - Make sure the pad and all attachment tabs do not

interfere with the latch points on the Child Restraint.

Attach the Head Rest Fabric by sliding the Adjustment

Strap through the button hole on the top of the fabric and

then wrapping the fabric around the Head Rest frame.

HEAD REST

CROSS BAR

Flip the Carrier over and pull the Harness Straps

through the openings. Make sure the Harness Straps are

not twisted and above the Head Rest Cross Bar.

Re-attach the Shoulder Pads and Crotch Strap Pad.

Re-attach the Head Rest Insert, Newborn Positioner and

Canopy, if needed. Refer to User Guide if needed.