Specifications & Ordering - Marti Electronics SRPT-40A User Manual

Model SRPT-40A
Remote Pick-Up Broadcast Transmitter
SPECIFICATIONS & ORDERING
Frequency Bands and
Maximum Output Power:
Frequency Resolution:
RF Connector:
Operating Temp. Range:
Modulation (Specify):
Preselect Storage
Channels:
Frequency Stability:
Spurious Emissions:
Audio inputs:
Modulation Control:
Encoding:
Metering/Indicators:
Controls:
Power Requirements:
Accessory Connector:
See ORDERING INFORMATION below.
12.5 or 10.0 KHz steps (user selectable)
Type N-Female
-10 Cº to +45 Cº
10KOF3E FCC Frequency Group P
25KOF3E FCC Frequency Group K, L, N2
50KOF3E FCC Frequency Group N1, R
Or special order
Can store and recall up to 10 frequency channels.
Mobile: .00025%
Base: .00025%
Less than 60 dB
Four balanced microphone (150 ohms) inputs (XLR-3) with
mixing controls. One input switchable to balanced line level
at microphone #4 input and D connector on rear panel.
Broadcast-quality compressor/limiter built in.
Subaudible 27 Hz. tone encoder built in.
Illuminated meter indicates forward and reverse power, PA
current, B+, and audio compression. LEDs indicate
transmit, AFC lock, high VSWR, and temperature.
(4) INPUT LEVEL, METER control knob, ENCODE
switch, FREQUENCY SELECT switches, EXECUTE
switch, POWER ADJUST pot, TRANSMIT switch, and
MONITOR jack.
90 to 264 VAC, 50/60 Hz
DC operation on 12 - 15 volts or 15 – 30 volts.
15-pin D connector for DC power, remote control, encode,
line level input.
2