Marti Electronics SRPT-40A User Manual page 10

Rpu transmitter
Hide thumbs Also See for SRPT-40A:
Table of Contents

Advertisement

THIS EQUIPMENT MUST BE OPERATED WITH A 3-PRONG, GROUNDED, 90-264 VOLT, AC
FAILURE TO USE A PROPERLY GROUNDED OUTLET COULD RESULT IN A SAFETY HAZARD
IF AN EXTENSION CORD IS USED, IT MUST BE THE THREE-WIRE GROUNDING TYPE TO
DO NOT CUT OFF THE GROUND PIN OF A 3-PRONG PLUG!
EXCESSIVELY LONG EXTENSION CORDS SHOULD BE AVOIDED SINCE THE VOLTAGE DROP
DO NOT OPERATE WHERE PERSONNEL TOUCHING THE TRANSMITTER (OR ITS
MICROPHONE, ANTENNA, OR OTHER CONNECTED EQUIPMENT) ARE STANDING ON WET
3.
For locations where AC power is not available, the SRPT-40A can be powered from a fully charged automobile
battery. The SRPT-40A draws eight (8) amps at 12.6 volts DC and at 50 Watts.
4.
Connect a portable antenna such as the Marti PAV/150, PAV-450, or YC-450 to the ANTENNA connector on the
back of the transmitter.
Mobile Installation
The SRPT-40A transmitter can be installed in the vehicle where the TRANSMIT/STANDBY function can be
operated directly, or the transmitter can be located elsewhere (in the trunk of a car or rear of a van) and controlled
remotely. The choice depends upon the type of vehicle and the type of operation anticipated. The antenna(s) are usually
mounted on top of the vehicle to provide maximum height.
Transmitter Mounting
1.
Locate transmitter where vent holes on top and rear of unit are not obstructed. Leave enough space for the mic. plug
on the front panel and the accessory plug on rear of unit.
2.
Hook the four mounting fasteners (in retracted position in the four slots on the sides of the transmitter. See Fig. 1.
(Fasteners are in Mobile Mounting Kit, 700-251).
3.
Mark the location of the two mounting holes in each fastener bracket. Drill 7/64" diameter holes into the mounting
surface at the marked places for #6 x 1/2" sheet metal screws.
4.
Attach the mounting fasteners with the sheet metal screws provided. Secure the transmitter with the fasteners.
WARNING
OUTLET RECEPTACLE!
OR FAULTY EQUIPMENT PERFORMANCE.
INSURE SAFETY.
WARNING
CAN DEGRADE EQUIPMENT PERFORMANCE.
DO NOT ALLOW THE SRPT-40A TO GET WET.
GROUND OR CONCRETE.
6

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents