Marti Electronics SRPT-40A User Manual page 21

TRANSMIT LED
When the TRANSMIT/STANDBY switch is in the STANDBY position, the SRPT-40A will not transmit and the
TRANSMIT LED will be off.
When the TRANSMIT/STANDBY switch is in the TRANSMIT position but the SYNTHESIZER is not ready, the
SRPT-40A will not transmit and the TRANSMIT LED will flash red.
When the TRANSMIT/STANDBY switch is in the TRANSMIT position and the SYNTHESIZER is ready (which
is always three seconds after the SYNTHESIZER becomes locked), the SRPT-40A will transmit and the TRANSMIT
LED will be on, solid red.
TRANSMIT/STANDBY Switch
This switch should be placed in the "STANDBY" position at least 1 minutes before transmission is anticipated. This
activates all audio circuits, MONITOR jack and METER. Current drain is minimal in "STANDBY" position. The
TRANSMIT/STANDBY switch is placed in the "TRANSMIT" position when transmission is desired. The
TRANSMIT/STANDBY switch should be returned to the "STANDBY" position as soon as a transmission is completed.
17