Wiring Connection - Kenwood KMM-204 Instruction Manual

INSTALLATION/CONNECTION

Wiring connection

If your car does not have an ISO terminal:
We recommend installing the unit with a commercially available custom
wiring harness specific for your car and leave this job to professionals for
your safety. Consult your car audio dealer.
When connecting to an external amplifier, connect its ground wire to the
car's chassis to avoid damaging the unit.
Connecting the ISO connectors on some VW/Audi or Opel
(Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring harness as
illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Pin Color and function (for ISO connectors)
A4 Yellow
1
A5 Blue/White*
A7 Red
A8 Black
B1/B2 Purple ]/Purple/black [
B3/B4 Gray ]/Gray/black [
B5/B6 White ]/White/black [
B7/B8 Green ]/Green/black [
16
ENGLISH
Fuse (10 A)
Yellow (Battery wire)
Ignition wire (Red)
Unit
Battery wire (Yellow)
: Battery
: Power control
: Ignition (ACC)
: Earth (ground) connection
: Rear speaker (right)
: Front speaker (right)
ISO connectors
: Front speaker (left)
: Rear speaker (left)
If no connections are made, do not let the wire come out from the tab.
Light blue/yellow
Red (Ignition wire)
(Steering remote
control wire)
2
Blue/White*
Red (A7)
(Power control wire/
Antenna control wire)
Yellow (A4)
Brown
(Mute control wire)
NOTE: Total output for Blue/White wire (*
Output terminals
Antenna terminal
STEERING WHEEL
REMOTE INPUT
To the steering wheel remote control
REMOTE CONT
adapter
To the power control terminal when
ANT CONT
using the optional power amplifier or
P. CONT
to the antenna control terminal in the
vehicle
To the terminal that is grounded
when the telephone rings or during
conversation. ( 13)
MUTE
(To connect the Kenwood navigation
system, refer your navigation manual.)
1 2
) + (* ) is 12 V 350 mA