Table of Contents
Advertisement
18
www.electrolux.com
• Seal the gap between the worktop and
glass ceramic with silicone.
• Put some soapy water on the silicone.
• Pull off the excess silicone with the
scraper.
8.6 Installation of more than one
hob
Supplied accessories: connection bar,
heat-resistant silicone, rubber shape,
sealing stripe.
Use only a special heat-
resistant silicone.
The worktop cutout
Distance
from the
wall
Depth
50 mm
minimum 50 mm
490 mm
50 mm
min.
25 mm
min.
2 mm
Width
Example:
580 mm
Assembly
1. Calculate correct cutout dimensions.
2. Prepare cutout in the worktop.
3. One by one place the hobs on a soft
surface (for example on a blanket) with
the bottom side up.
4. Attach the supplied seal stripe to the
lower edge of the hob along the outer
edge of the glass ceramic.
5. Loosely screw the fixing plates into the
correct holes in the protective casing.
6. Insert first hob into the worktop
cutout. Than insert the connection bar
sum of all widths of hobs
that you install minus 20 mm
+
-
=
360 mm
20 mm
920 mm
Advertisement
Table of Contents
