Table of Contents
Advertisement
NAME OF PARTS
Remote controller
Display
1
2
3
4
5
11
13
1 "MODE" button
2 "SET TEMP. (
3 "10 °C HEAT" button
4 "ECONOMY" button
5 "SLEEP" button
6 "FAN" button
7 "START/STOP" button
8 " SET" button (Vertical)
9 "
SET" button (Horizontal)
0 "
SWING" button
A "TIMER MODE" button
B "TIMER SET (
C "CLOCK ADJUST" button
D "RESET" button
E "TEST RUN" button
G This button is used when installing the condi-
tioner, and should not be used under normal
conditions, as it will cause the air condition-
er's temperature function to operate incor-
rectly.
G If this button is pressed during normal opera-
tion, the unit will switch to test operation
mode, and the receiver unit control panel's
OPERATION Indicator Lamp (green) and
TIMER Indicator Lamp (orange) will begin to
flash simultaneously.
G To stop the test operation mode, press the
"START/STOP" button to stop the air condi-
tioner.
En-3
16
6
7
8
9
10
14
12
15
/
)" button
/
)" button
Display panel
To facilitate explanation, the accompanying illustration
has been drawn to show all possible indicators; in ac-
tual operation, however, the display will only show those
indicators appropriate to the current operation.
F Signal Transmitter
G Temperature SET Display
H Operation Mode Display
I SLEEP Display
J Transmit Indicator
K Fan Speed Display
L SWING Display
M Timer Mode Display
N Clock Display
Some indoor units may not be equipped with the func-
tions corresponding to all of the buttons on this remote
controller. The indoor unit will beep and the OPERATION,
TIMER and ECONOMY lamp flash when a remote con-
troller button is pressed if the function is not available.
21
22
23
24
Hide quick links:
Advertisement
Table of Contents
