Cleaning And Care; Selecting The Remote Controller Signal Code - Fujitsu UTY-LRHYM Operating Manual

CLEANING AND CARE

• Before cleaning the unit, be sure to stop the unit and disconnect the power supply.
• Turn off the electrical breaker.
• A fan operates at high speed inside the unit, and personal injury could result.
G When used for extended periods, the unit may accumulate dirt inside, reducing its performance. We recommend that the unit
be inspected regularly, in addition to your own cleaning and care. For more information, consult authorized service personnel.
G When cleaning the unit's body, do not use water hotter than 40 °C, harsh abrasive cleansers, or volatile agents like
benzene or thinner.
G Do not expose the unit body to liquid insecticides or hairsprays.
G If the unit will not be operated for a period of 1 month or more, be sure to allow the inner parts of the unit to dry
thoroughly, in advance, by operating the unit in fan mode for half a day.
Cleaning the Air Filter
G Dust can be cleaned from the air filter either with a vacuum cleaner, or by washing the filter in a solution of mild detergent
and warm water. If you wash the filter, be sure to allow it to dry thoroughly in a shady place before reinstalling.
G If dirt is allowed to accumulate on the air filter, air flow will be reduced, lowering operating efficiency and increasing noise.

SELECTING THE REMOTE CONTROLLER SIGNAL CODE

When 2 or more air conditioners are installed in a room and the remote controller is operating an air conditioner other than the
one you wish to set, change the signal code of the remote controller to operate only the air conditioner you wish to set
(4 selections possible).
When 2 or more air conditioners are installed in a room, please contact your retailer to set the individual air conditioner signal
codes.
Selecting the Remote controller Signal Code
Use the following steps to select the signal code of the remote controller. (Note that
the air conditioner cannot receive a signal code if the air conditioner has not been
set for the signal code.)
1 Press the "START/STOP" button until only the clock is
displayed on the remote controller display.
2 Press the "MODE" button for at least 5 seconds to dis-
play the current signal code (initially set to ).
3
Press the "SET TEMP. (
signal code between
display to the air conditioner signal code.
4
Press the "MODE" button again to return to the clock
display. The signal code will be changed.
If no buttons are pressed within 30 seconds after the signal code is displayed, the system returns to the original clock
display. In this case, start again from step 1.
The air conditioner signal code is set to A prior to shipment. Contact your retailer to change the signal code.
The remote controller resets to signal code A when the batteries in the remote controller are replaced. If you use a
signal code other than signal code A, reset the signal code after replacing the batteries.
If you do not know the air conditioner signal code setting, try each of the signal codes (
code which operates the air conditioner.
CAUTION
/ )" buttons to change the
. Match the code on the
) until you find the
En-10