Preparation; Insert Batteries - Fujitsu UTY-LRHYM Operating Manual

PREPARATION

• Take care to prevent infants from accidentally swallowing batteries.
• When not using the Remote Controller for an extended period, re-
move the batteries to avoid possible leakage and damage to the unit.
• If leaking battery fluid comes in contact with your skin, eyes, or mouth, imme-
diately wash with copious amounts of water, and consult your physician.
• Dead batteries should be removed immediately and disposed of properly,
either in a battery collection receptacle or to the appropriate authority.
• Do not attempt to recharge dry batteries.
Load Batteries (R03/LR03 × × × × × 2)
1 Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the
2

Insert batteries.

Be sure to align the battery polarities (
3 Close the battery compartment lid.
Set the Current time
1
Press the "CLOCK ADJUST" button.
Use the tip of a ball-point pen or other small object to press the button.
2
Use the "TIMER SET (
clock to the current time.
button: Press to advance the time.
button: Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
1 minute increments; hold the buttons depressed to change the time
quickly in 10 minute increments.)
3 Press the "CLOCK ADJUST" button again.
This completes the time setting and starts the clock.
To Use the Remote Controller
G The Remote Controller must be pointed at remote control signal receiver to oper-
ate correctly.
G Operating Range: About 5 m.
G When a signal is properly received by the receiver unit control panel, some lamp
will be flashed.
G If no lamp is flashed, press the Remote Controller button again.
Remote Controller Holder
Insert
Press in
Screws
1 Mount the Holder. 2 Set the Remote Controller.
CAUTION
) correctly.
/ )" buttons to adjust the
Slide up
Pull out
3 To remove the Remote
Controller (when use at
hand).
Never mix new and used batteries, or
batteries of different types.
Batteries should last about 1 year under
normal use. If the Remote Controller's op-
erating range becomes appreciably re-
duced, replace the batteries and press the
"RESET" button with the tip of a ballpoint
pen or other small object.
mark.
En-4