PROCEDURE
Please refer to the installation manual of each indoor unit for details.
If the wiring length is 10m, replace with
receiver unit wire C (optional parts).
Receiver unit wire A 5m
Bundle and fasten
the excess wiring.
Indoor unit
MAX. 10m
Ceiling
Connect the wires, and then use heat shrink tubing to
protect the connection from dust and water droplets.
EXAMPLE
After shrinking
both ends of
the heat shrink
tubing, seal
CONNECT
the ends with
Heat shrink
electrical tape.
tubing
(ø25 L130)
Provide a trap in the receiver
unit wiring.
(To prevent water droplets
from entering the receiver unit
and the connector)
Receiver unit
8. TURNING ON THE POWER
1 Turn on the breaker.
2 Make sure that the operation indicator lamp and timer indicator lamp are
slowly flashing alternately.
•
If the auto restart function has been set, the air conditioner will operate
with the settings immediately before the power supply was turned off.
•
If an error has occurred, the lamps on the receiver unit will flash quickly
to indicate the error code. (Referring to
of this installation manual)
13
9. SETTING THE REMOTE CONTROLLER
9.1. Load batteries (R03/LR03 × 2)
1 Press and slide the battery compartment lid on the reverse side to open
it.
Slide in the direction of the arrow while pressing the
mark.
2 Insert batteries.
Be sure to align the battery polarities (
) correctly.
3 Close the battery compartment lid.
CAUTION
•
Take care to prevent infants from accidentally swallowing batteries.
•
When not using the Remote Controller for an extended period, remove
the batteries to avoid possible leakage and damage to the unit.
•
If leaking battery fluid comes in contact with your skin, eyes, or mouth,
immediately wash with copious amounts of water, and consult your
physician.
•
Dead batteries should be removed immediately and disposed of properly,
either in a battery collection receptacle or to the appropriate authority.
•
Do not attempt to recharge dry batteries.
NOTES
•
Never mix new and used batteries, or batteries of different types.
•
Batteries should last about 1 year under normal use. If the Remote
Controller’s operating range becomes appreciably reduced, replace the
batteries and press the RESET button with the tip of a ballpoint pen or
other small object.