D-Link DSL-2885A User Manual page 37

Section 4 - Configuration
Select PPPoE if your Internet connection requires you to enter a username and password. This information is provided by your Internet Service
Provider (ISP).
PPPoE Session: Choose Share with IPv4 to re-use your IPv4 PPPoE username and
password, or Create a new session.
Username: If you selected Create a new session above, enter the PPPoE
username provided by your ISP here.
Password: If you selected Create a new session above, enter the PPPoE
password provided by your ISP here.
Address Mode: Select Static IP if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses. In most cases, select Dynamic IP.
IP Address: Enter the IP address provided by your ISP (Static IP only).
MTU: Maximum Transmission Unit - you may need to change the MTU for
optimal performance with your ISP.
DNS Type: Select either Obtain DNS server address automatically or Use the
following DNS address.
Primary DNS If you selected Use the following DNS address above, enter the
Server: primary DNS server address.
Secondary DNS If you selected Use the following DNS address above, enter the
Server: secondary DNS server address.
Enable DHCP- Enable or disable prefix delegation services.
PD:
D-Link DSL-2885A User Manual
PPPoE
48