Table of Contents
Advertisement
Parallel Channels (ABCD) and (E F G H)
For One Loudspeaker
Full power to one loudspeaker; Use one 2-wire cable, connect to:
• T3+/T4- (Loudspeaker ABCD)
For Multiple Loudspeakers
Full power for multiple loudspeakers in parallel Use up to four 2-wire
cables, connect to:
• T1+/T2- (Loudspeaker E)
• T3+/T4- (Loudspeaker F)
• T5+/T6- (Loudspeaker G)
• T7+/T8- (Loudspeaker H)
CHANNEL CONFIGURATION
Q ABCD
1 Channel: A B C D
Channel Configuration Locked to Design
Connect the Loudspeakers
1.
Connect the loudspeaker wiring to the 8-pin Euro-style connector as
needed for your amplifier's configuration.
2.
Install the female 8-pin Euro-style connector onto the male connector
on the rear of the amplifier as shown in Figure 10.
3.
Use a Phillips screwdriver to secure the connector.
AC Mains
WARNING!!: When the AC Power is on, there is a
potential of having dangerous voltage at the output
terminals on the rear of the amplifier. Use caution not to
touch these contacts. Turn off the AC Mains disconnect
switch prior to making any connections.
1.
Make sure the power switch on the rear of the amplifier is off.
2.
Connect the IEC power cord to the AC receptacle. (Figure 11)
AC Power On
After connecting the outputs to the loudspeakers, you may turn the amplifier on.
1.
Make sure the output gain settings for all audio-source devices (CD Players, Mixers, Instruments,
etc.) are at the lowest output (max attenuation).
2.
Turn on all audio sources.
3.
Turn the AC Mains power switch on the back of the amplifier to ON. The amplifier starts in the state
it was in when power was removed. If the amplifier is in Standby or Mute All mode (Power button
LED solid red or blinking), press the Power button to change the amplifier to Run mode.
4.
You can now bring up the outputs of your audio sources.
A-TD-001522-01
CHANNEL CONFIGURATION
Q EFGH
1 Channel: E F G H
Channel Configuration Locked to Design
— Figure 9 —
OUTPUTS TO SPEAKERS
-
CH D
+
-
CH C
+
-
CH ABCD
CH B
+
-
+
T3
T4
-
CH A
+
In 4-1 Parallel (ABCD or EFGH) only
T1+, T3+, T5+, and T7+ are electrically the same point
T2-, T4-, T6-, and T8- are electrically the same point
7
OUTPUTS TO SPEAKERS
+
T8
T1
CH E
-
T7
T2
+
T6
T3
CH F
-
T5
T4
+
T4
T5
CH G
-
T3
T6
+
T2
T7
CH H
-
T1
T8
— Figure 10 —
— Figure 11 —
SETTINGS CAN BE
CONFIGURED FOR
70V, 100V AND
200V DIRECT
OUTPUT.
CH EFGH
+
-
T1
T2
+
-
T3
T4
+
-
T5
T6
+
-
T7
T8
Hide quick links:
Advertisement
Table of Contents
