English (GB) Service instructions Original service instructions. 2. General information Position numbers of parts (digits) refer to the drawing in section CONTENTS view. Position numbers of tools (letters) refer to 7. Exploded section tools. For parts without position numbers, see Page 5.
12. Light up the chamber with a torch through one of the holes 6. Instructions for dismantling and assembly (air vent or drain). Through the other hole, slacken the socket screws (pos. 113) of the lower shaft seal (pos. 105b). 6.1 Dismantling See fig.
Page 5
16. Fit coupling (pos. 8), according to figs and 5, and tighten 6.2 Assembly screws (pos. 9). 1. Fit rubber springs (pos. 60) and O-ring (pos. 37) in pump head (pos. 2b). 2. Press lower shaft seal (pos. 105b) down in pump head. Make sure to fit it from underneath the pump head.
Need help?
Do you have a question about the CR 32 and is the answer not in the manual?
Questions and answers