Honeywell CO301PC User Manual page 3

USE & OPERATION (CONTINUED)
FUNCTION BUTTONS (CONTINUED)
COOL
Touch the COOL button until it is illuminated on the display screen. This activates evaporative cooling.
The water pump will operate and you will feel the cooler air after the Honeycomb Cooling Media is
completely wet. When COOL is not illuminated, the unit switches to a fan only mode, without
evaporative cooling.
SAFETY LOCK
To avoid accidentally touching and changing the set air cooler settings, you can touch both the
POWER + COOL buttons at the same time to lock the control panel. Touch both POWER + COOL at
the same time again to unlock the control panel buttons.
REMOTE CONTROL
Note:
The remote control requires two new AAA dry cell batteries for replacement.
Open the battery compartment at the back of the remote control and insert two batteries inside. Care
must be taken to insert the batteries according to the correct polarity (+ / –) markings shown inside
the battery compartment.
Always point the remote control signal transmitter towards the unit when operating. Make sure that
the signal path is not obstructed.
Remove the batteries if the unit is not going to be used for an extended period of time.
Do not drop the remote control.
Do not mix different types of batteries such as alkaline, carbon-zinc, or rechargeable batteries.
Do not mix old and new batteries.
Do not recharge the battery.
Exhausted batteries are to be removed from the product and safely disposed of as per local regulations.
Do not dispose of batteries in fire. Batteries may explode or leak.
WARNING: Caution for ingestion of the small battery. Keep away from children and animals.
COOLER LOCATION
Make sure to position the air cooler correctly before you set up and start using the product. Please refer
to the COOLER LOCATION section of the separate Safety & Maintenance Guide.
FILLING WITH WATER
It is ideal to use the Continuous Water Supply Connection to run the unit for long periods of time
without refilling the tank. This also helps prevent pump failure in case the cooler is running with
inadequate water in the tank.
CAUTION: Unplug the unit from the electrical power outlet before emptying or refilling the water tank.
Continuous Water Supply Connection:
For a continuous water supply, you will need a garden hose that is
connected to a mains water supply.
Locate the male connector at one end of the garden hose. Insert the
garden hose connector into the water inlet valve of the cooler. Screw
and tighten the water inlet valve onto the threaded part of the garden
hose connector, making sure the hose connector is secured to ensure
there will be no leaks. If there is a leakage, the hose and the water inlet
valve may not be connected properly. Try to disconnect, replace and
tighten the water inlet valve again.
+
Power : ON / OFF
Speed : Low / High
Cool : Controls cooling or fan option
Swing : Controls the motion of the louvers
Timer : Controls the Timer function for automatic off
EN 2
Water Inlet Valve
Garden Hose