Wipers And Washers - Honda Clarity 2017 Electric Owner's Manual

Wipers and Washers

■
Windshield Wipers/Washers
Pull to
use
washer.
Intermittent Time
Adjustment Ring
MIST
OFF
INT
LO: Low speed wipe
HI: High speed wipe
uuOperating the Switches Around the Steering WheeluWipers and Washers
The windshield wipers and washers can be
used when the power mode is in ON.
■
MIST
The wipers run at high speed until you release
the lever.
■
Wiper switch (OFF, INT, LO, HI)
Move the lever up or down to change the
wiper settings.
■
Adjusting wiper operation
Turn the adjustment ring to adjust the wiper
operation.
Lower speed, fewer sweeps
Higher speed, more sweeps
■
Washer
Sprays while you pull the lever toward you.
When you release the lever for more than one
second, the spray stops, the wipers sweep two
or three more times to clear the windshield,
then stop.
1Wipers and Washers
NOTICE
Do not use the wipers when the windshield is dry.
The windshield will get scratched, or the rubber
blades will get damaged.
Turn the washers off if no washer fluid comes out.
The pump may get damaged.
When the wiper motor is kept running under heavy
load for extended periods of time, this protection
feature is activated, and the wiper speed may
decrease or motor operation may stop temporarily.
This function will be canceled within a few minutes
once the load has been reduced; the wiper operation
returns to normal.
If the vehicle speeds up while the wipers are
operating intermittently, the length of the wipe
interval shortens.
When the vehicle speeds up, the wiper operation's
shortest delay setting (
become the same.
NOTICE
In cold weather, the blades may freeze to the
windshield.
Operating the wipers in this condition may damage
the wipers. Use the defroster to warm the
windshield, then turn the wipers on.
Continued
) and the LO setting
157