Safety Precautions - S-Energy SN245P-10 Installation Manual

3. Safety Precautions

These "Safety Precautions" should be thoroughly understood before installing.
Danger
When connecting with '+', '-' in module, the cable shall be equipped with direct current, and shall not connect or disconnect with module when electricity
flows. If an abnormal or old electrode is connected, you may get injured by sparks arising from direct current.
※ PV module installation should be performed by qualified person only.
Caution
|Caution|
|Recommendation|
Store a module in an indoor warehouse before
installing.
| Caution |
|Recommendation|
The utmost care is required for preventing
corrosion/contamination/deterioration due to
mishandling when you load/outdoor load/installation.
Always wear protective equipment while
working with PV modules.
Working on a PV system requires following all applicable
local codes and wearing protective equipment, and
must be performed by appropriately qualified and
authorized personnel only.
[Caution]
Do not place heavy objects on the module.
Stepping on or allowing objects to fall on the module
may damage certain parts of the product and slow
down the performance significantly, or causes risks to
the whole system.
[Caution]
Do not install when snowy, rainy, and windy
days.
Do not install where water remains on the
ground.
|Recommendation|
Install when the weather is clear.
| Caution |
All surfaces except frames are fragile, so touch only
the frame areas when moving/installing. And do
not allow direct shock or hit to the module.
|Recommendation|
PV module should be installed by a
two person team. Be careful when
handling because the shock may
cause damage or low performance.