Operating With Ir450 Illuminator; Preparation For Storage - ATN PS-22 Operator's Manual

3. After disconnecting the remote control screw the cap onto the
plug.

2.2.5. OPERATING WITH IR450 ILLUMINATOR

Infra-red (IR) Illuminators are common for night vision technolo-
gy. The IR light greatly enhances the performance of your device,
while remaining almost totally invisible to the naked eye. Staying
in the dark, switch on your night vision device. If the visibility is
low, you may use ATN IR450 to improve the situation. Still, you
should remember that the IR illuminator is just a source of infrared
light so the greater is the chosen range of observation, the lesser
its brightness becomes.

2.2.6. PREPARATION FOR STORAGE

A. Shutdown. Perform the following procedures to shut
down the sight.
1. Turn the sight function switch to the OFF position.
2. R e m o v e t h e s i g h t f r o m t h e w e a p o n o r d a y t i m e
riflescope.
3 Remove attached accessories.
WARNING
Do not carry batteries in pockets containing metal objects
such as coins, keys, etc. Metal objects can cause the batteries
to short circuit and become very hot.
B. Packaging After Use.
1. Remove batteries.
2. Inspect the batter y housing for corrosion or moisture.
Clean and dry if necessary.
3. Install objective lens cap.
NOTE
Prior to placing MUNVM into storage case, ensure MUNVM and
case are free of dirt, dust, and moisture.
4. Place the sight into the storage case, close and latch.
5. Return to storage area.
2-19