Operating Procedures - ATN PS-22 Operator's Manual

PLUG CAP
CONTROLS
Function Switch
Focus Adjust-
ment Knob
Remote Control

2.2.3. OPERATING PROCEDURES

These procedures should be performed under night light condi-
tions only.
CAUTION
Use of the PS-22 under high light conditions may damage the
image intensifier.
1. Make sure the battery is installed as indicated on the sight
body.
REAR VIEW
FIGURE 2-16. PS-22 CONTROLS
TABLE 2-2. PS-22 CONTROLS
STB — the sight is in standby mode.
OFF — the sight is off.
ON — the sight is on. Switch's spring is loaded.
Focuses the input lens. Adjusts for sharpest view of
scene.
Switches the sight from standby to operating mode.
FOCUS ADJUSTMENT KNOB
REMOTE CONTROL
PLUG
FUNCTION
2-17