Table of Contents
Advertisement
3 Handling
3.1
Transport
3.2
Storage
3.3
Assembly information
3.3.1
Mounting instructions
Checking system components
Megapress
Observe the following when transporting pipes:
Do not pull the pipes over the sill. The surface could be damaged.
n
Secure pipes during transportation. Pipes may become bent due to
n
shifting.
Do not damage the protective caps on the pipe ends and do not
n
remove them until immediately before mounting. Damaged pipe
ends may not be pressed.
In addition, observe the instructions provided by the pipe
manufacturer.
For storage, comply with the requirements specified in the applicable
Ä „Regulations from section: Storage" on page 7 :
regulations, see
Store components in a clean and dry place.
n
n
Do not store the components directly on the floor.
Provide at least three points of support for the storage of pipes.
n
Where possible, store different sizes separately.
n
Store small sizes on top of larger sizes if separate storage is not pos-
sible.
To prevent contact corrosion, store pipes of different materials sepa-
n
rately.
In addition, observe the instructions provided by the pipe
manufacturer.
System components may, in some cases, become damaged through
transportation and storage.
Check all parts.
n
Replace damaged components.
n
Do not repair damaged components.
n
Contaminated components may not be installed.
n
Handling
17 from 32
Hide quick links:
Advertisement
Table of Contents
