Bio Compression SC-3008-DL Operating Instructions Manual page 13

3. Cleaning solution should consist of 1/3 cup of laundry detergent per 1 gallon of
warm tap water. Use either a large sink or plastic tub able to hold enough solu-
tion (depending on size and quantity of garments) to completely submerge the
garment leaving the latch connector bars out of the water.
4. Garment should be soaked for 30 minutes with mild agitation every 5 to 10
minutes while keeping it below water surface.
5. Thoroughly rinse garment with warm tap water and allow to air dry.
WARNING! Never allow the Latch Connectors to be submerged into the
water. If water enters the inside of the garment, damage may occur to the
device.
6. Harder to remove soil on surface of garment may require additional washing by
hand with a clean towel while submerged. Avoid using any abrasive materials
such as scrubbing pads or chemicals that could cause damage to the exterior sur-
face of garment.
7. Re-Submerge garment for 30 minutes (with exception of tubing connectors) in so-
lution consisting of 1 cup of bleach per 1 gallon of warm tap water, again agitating
garment every 5 to 10 minutes while keeping garment below water surface.
Rinse garment thoroughly with warm tap water and allow to air dry. This com-
pletes the disinfecting step.
WARNING! DO NOT place garment in washing machine.
WARNING! DO NOT use the tubing or valves as "handles" for carrying,
handing or storing garment.
13