Advertisement
1.
Washer (M8)
2. Locknut (NIM8-1.25)
3. Deck belt guard assembly
3. Verify that the guard is clear of all moving parts
across their full range of operation, that it will not
cause damage to wires, hoses or other components
and that it will not interfere with the safe operation
of the cutting deck.
4
Installing the Rear Belt Guard
Parts needed for this procedure:
2
Rear belt guard
Procedure
1. On the each side of the machine, loosen, but do not
remove, the 2 hex bolts located on the frame just
in front of each rear tire.
2. Take a rear belt guard and slide the notches at the
top of the plate under the hex bolt heads and tighten
the bolts securely; see Figure 4.
Figure 3
4. Hex bolt (M8-1.25X20)
5. Deck
1. Rear belt guard
3. Verify that the guard is clear of all moving parts
across their full range of operation, that it will not
cause damage to wires, hoses or other components
and that it will not interfere with the safe operation
of the traction unit.
5
Attaching the Deck
No Parts Required
Procedure
1. Slide the deck back under the machine, mount it to
the traction unit and adjust it as described in the
Operator's Manual for this model.
2. Verify that the belt guards are clear of all moving
parts across their full range of operation, that they
will not cause damage to wires, hoses or other
components and that they will not interfere with the
safe operation of the mowing deck and the traction
unit.
3
Figure 4
2. Hex bolts
Advertisement
