ECS L4S5MG Manual page 40

Onboard Parallel Port (378/IRQ7)
This option is used to assign the I/O address and interrupt request (IRQ) for
the onboard parallel port.
Parallel Port Mode (ECP)
Enables you to set the data transfer protocol for your parallel port. There are
four options: SPP (Standard Parallel Port), EPP (Enhanced Parallel Port),
ECP (Extended Capabilities Port) and ECP+EPP.
SPP allows data output only. Extended Capabilities Port ( E CP) and Enhanced
Parallel Port (EPP) are bi-directional modes, allowing both data input and output.
ECP and EPP modes are only supported with EPP- and ECP-aware peripherals.
ECP Mode Use DMA (3)
When the onboard parallel port is set to ECP mode, the parallel port can use
DMA 3 or DMA 1.
Game Port Address (201)
This item sets the I/O address for the game port.
Midi Port Address (330)
This item sets the I/O address for the Midi function.
Midi Port IRQ (10)
This item sets the interrupt request for the Midi function.
Press <Esc> to return to the Integrated Peripherals screen.
USB Controller (Enabled)
Enable this item if you plan to use the Universal Serial Bus ports on this
mainboard.
USB Keyboard Support (Disabled)
Enable this item if you plan to use a keyboard connected through the USB
port in a legacy operating system (such as DOS) that does not support Plug
and Play.
Onboard LAN (Enabled)
Use this item to enable and disable the onboard LAN function.
IDE HDD Block Mode (Enabled)
Enable this field if your IDE hard drive supports block mode. Block mode
enables BIOS to automatically detect the optimal number of block read and
writes per sector that the drive can support. It also improves the speed of
access to IDE devices.
SC Port Address (Disabled)
The smart card reader needs a 16-byte fixed I/O address to access data. You
may need an optional module to be able to use this function. When this item is
set, the following item becomes available:
•
SC Port IRQ: Enables you to set the smart card IRQ.
36