JVC MX-G68V Service Manual page 16

MX-G68V/MX-G65V
Removing the flywheel. (Fig.5 to 7)
Prior to performing the following procedure,
removing the cassette mechanism.
1.
Remove the cut washers at a and b from the
capstan shaft. Then remove the flywheel.
When reassembling the flywheel, be sure
to use new cut washers as they cannot
be reused.
Removing the motor.
Prior to performing the following procedure,
removing the cassette mechanism.
1.
Unsolder the solder point on the motor terminal.
2.
Remove the capstan belt from the motor pulley.
3.
Remove the two screws F attaching the
motor bracket.
4.
Remove the two screws G attaching the motor.
Motor bracket
G
Fig.9
Capstan belt (Flat)
1-16
(Fig.7 to 9)
Drive belt
Capstan belt (Flat)
Motor
G
Capstan belt (Flat)
Cassette mechanism
Capstan shaft b
Fig.5
b
Washer
Drive belt
Capstan belt (Flat)
Fig.6
Drive belt
Capstan belt (Flat)
Fig.7
F
Motor bracket
Cassette mechanism
F
Fig.8
a
Capstan shaft
a
Solder point
Drive belt