Table of Contents
Advertisement
<CD changer unit>
Prior to performing the following procedure, remove
the CD changer unit.
Removing the CD tray (See Fig.1 to 3)
1.
Disconnect the card wire from connector SW1 of the
video CD board.
2.
Turn the black loading pulley gear on the under side
of the CD changer unit in the direction of the arrow
and draw the CD tray toward the front until it stops.
3.
Disconnect the card wire from connector CW6 of the
Video CD board on the upper side of the CD changer
unit.
4.
Push down the two tray stoppers marked a and pull
out the CD tray.
Reinstall the CD tray (See Fig.4 and 5)
1.
Align the gear-cam with the gear-tray as shown fig.4,
then mount the CD tray.
2.
When assembling the CD tray, take extreme care not
engage with gear-synchro.
Gear-cam
Gear-convert
Gear-convert
Gear-tray
Gear-tray
Gear-cam
timing point
Fig.4
Loading pulley
gear
Video CD
board
SW1
CD tray
CD tray
a
(Tray stopper)
Gear-tray
CD tray
MX-G68V/MX-G65V
CD tray
Fig.1
Fig.2
a (Tray stopper)
Video CD board
CW6
Fig.3
Gear-synchro
Fig.5
1-11
Advertisement
Table of Contents
