Software Programming; Changing Room Mode - Pressura RPM10 Operation And Service Manual

Software Programming

Programming the PresSura Model RPM10/RPM20 monitor is quick and easy if the proper
keystroke procedure is followed. The programming keys are defined first, followed by the
required keystroke procedure. At the end of this section is a programming example.
NOTE: It is important to note that the unit is always operating when programming. When a menu
item value is changed, the new value takes effect immediately after saving the change,
not when the unit returns to normal operating mode.
This section covers programming the instrument through the keypad and display. If
programming through network communications (see
computer's procedure. The changes take place immediately upon saving data in the
instrument.

Changing Room Mode

1. Press the Room Mode button for the room on the touchscreen.
2. Select the desired room mode by pressing on the desired room mode button at the bottom of
the screen.
NOTE: If a room mode is not selected, the PresSura monitor will return to the main running
screen after a short delay,
8
Figure 5. Main Running Screen
Figure 6. Room Mode Selection Screen
Appendix B), use the host
Part Two