Advertisement
Installation Precautions
Warnings
◆
The rack or cabinet should be adequately secured to prevent it
from becoming unstable, tilting, or falling.
◆
Devices installed in a rack or cabinet should be mounted as
low as possible, with the heaviest devices at the bottom and
progressively lighter devices above.
Cautions
◆
Ensure the power source circuits are properly grounded, then
use the power cord supplied with the switch to connect to the
AC power source.
◆
If your installation requires a different power cord than the
one supplied with the switch and/or power supply, be sure the
cord is adequately sized for the switch's current requirements.
In addition, be sure to use a power cord displaying the mark of
the safety agency that defines the regulations for power cords
in your country/region. The mark is your assurance that the
power cord can be used safely with the switch and power
supply.
◆
When installing the switch, the AC outlet should be near the
switch and should be easily accessible in case the switch must
be powered off.
◆
Ensure the switch does not overload the power circuits,
wiring, and over-current protection. To determine the
possibility of overloading the supply circuits, add together the
ampere ratings of all devices installed on the same circuit as
the switch and compare the total with the rating limit for the
circuit. The maximum ampere ratings are usually printed on
the devices near the AC power connectors.
◆
Do not install the switch in an environment where the
operating ambient temperature exceeds its specification.
◆
Ensure the airflow around the switch is not restricted. Leave at
least 7.6 cm (3inches) for cooling.
For additional safety and regulatory information, and switch
recycling information, refer to the safety and regulatory
documentation on the HP website at
www.hp.com/support/Safety-Compliance-EnterpriseProducts
Power Cords
Argentina
Australia/New Zealand
Brazil
Chile
China
Continental Europe
Denmark
India
Israel
Japan
Malaysia
Switzerland
South Africa
South Korea
Taiwan
Thailand
United Kingdom/Hong Kong/Singapore
United States/Canada/Mexico
WARNING
CAUTION
Japan Power Cord Warning
China Altitude Warning
Russia/Belarus/Kazakhstan/CEE Safety
HP USA Corporate Address
Hewlett-Packard Company
3000 Hanover Street, Palo Alto, California, 94304U.S.A.
8121-0729
8121-0837
8121-1071
8121-0735
8121-0943
8121-0731
8121-0733
8121-0564
8121-1004
8121-0736
8121-0739
8121-0738
8121-0737
8121-0731
8121-0964
8121-0734
8121-0739
8121-0740
– 3 –
FOR INDOOR USE ONLY. The switch, AC power cord, and all
connected cables are not designed for outdoor use.
Disconnect all power supply cords before servicing.
Débranchez tous les cordons d'alimentation avant
l'entretien.
仅适用于海拔 2000 米以下地区安全使用
Quick Start Guide
Advertisement
