Bestway Lay-Z-Spa Owner's Manual page 9

8-1
8. Locate the markings A and B on the bottom of the side tables and insert the corresponding clips by pressing
down on the tabs and slide the clips into position.
9
9. Align the table supports with Clips B and insert the locking pin. Repeat this step for the opposite table.
10. Rotate the locking pin 180° to lock them into position. Repeat this step for the opposite table.
11. Install the side tables on the beams.
12
12. Align the holes on the table supports to the holes on the U-Supports and insert the locking pin.
13. Rotate the two locking pins 180° to lock them into position. Repeat this step for the opposite table.
14
C C
A
A
B
B
14. Connect the pump to the spa by lining up the matching letters (A to A,B to B and C to C), and using the adapters to connect the pump to
the spa. Ensure the seals are properly in place and hand tighten the adapters securely.
15. Fill the spa using a garden hose. Fill the spa minimum water level to the water level printed on the spa wall.
16. Place the top leatheroid cover over the spa and zip it closed.
WARNING: This spa cover is not a substitute for adult supervision; child must be supervised at all times around the spa.
WARNING: Do not run the Lay-Z-Massage system when the cover is attached, air can accumulate inside the spa and cause irreparable
damage and bodily harm.
10
13
15
7
8-2
16
Press
S-S-000830