Table of Contents
Advertisement
WxK
Set the WIDTH to the following values
x = 0 width set to 0 kHz per data point
x = 1 width set to 1 kHz per data point
x = 2 width set to 2 kHz per data point
x = 3 width set to 5 kHz per data point
x = 4 width set to 10 kHz per data point
x = 5 width set to 20 kHz per data point
x = 6 width set to 50 kHz per data point
x = 7 width set to 100 kHz per data point
Uxxk
Set the User #1 SWR threshold to xx
xx must be in the range of 12 to 35
VxxK
Set the User #2 SWR threshold to xx
xx must be in the range of 12 to 35
BxxK (Directs the DATA BOX Field to retrieve the data contained in the Analyzer's Data box.
Refer to the F3: DATA BOX section for more detailed information on the response you will receive.)
Set the Data Box to xx, where xx must be the following:
xx = 00 Report width, and center frequency
xx = 01 Report SWR, and Return Loss
xx = 02 Report the Z, R, X, and Angle at the center frequency
xx = 03 Report equivalent L, C at center frequency
xx = 04 Report 2:1 Bandwidth, Q
xx = 05 Report lower (2:1) frequency, 20, upper (2:1) frequency
xx = 06 Report lower (X:1) frequency, X, upper (X:1) frequency
xx = 07 Report lower (Y:1) frequency, Y, upper (Y:1) frequency
xx = 08 Report minimum SWR, frequency @ minimum SWR
xx = 09 Report Normalize R, ±j Normalized X
xx = 10 Report frequency low, center frequency, frequency high
xx = 11 Report -offset, center frequency, +offset
xx = 99 Power off Analyzer
FxxxxxK
Set the center frequency to xxxxx (xxxxx must be in the range of 00400 to 54000.
Leading zeros are required.)
RESPONSES
Below is a list of "live" serial commands and responses (left column) and the information
communicated by each command/response (right column).
IK
; Illegal command sent
?
; Response from Analyzer
f12345K
; Illegal command sent (lower case "f")
?
; Response from Analyzer
18
Hide quick links:
Advertisement
Table of Contents
