Table of Contents
Advertisement
2
Unpack and identify the hardware
Before mounting and cabling VTS, you must unpack the hardware and verify the box contents.
Unpack all hardware
A. Unpack all hardware and retain packing materials.
B. Inspect the hardware and the contents of the box(es). If damage is apparent, contact the
carrier and your vendor.
C. Place hardware on a flat, stable work surface. Always lift the enclosures by the sides.
Because the hardware is heavy, it is recommended that you use an assistant when lifting it.
Confirm that you received the following components, in addition to this guide and the hardware:
•
VT5900-H
•
Power cords
•
HP ProLiant Essentials Foundation Pack CDs
•
HP ProLiant DL385 G5 Documentation CD and posters
•
HP Virtual TapeServer Base Release 6.04.03 DVD
•
Labels for bus numbers
•
Rail kit
•
VT5900-K
•
Power cords
•
HP ProLiant DL185 G5 Server Support and Documentation CD
•
HP ProLiant DL185 Generation 5 Server Installation Sheet
•
HP Virtual TapeServer Base Release 6.04.03 DVD
•
External DVD/CD-ROM drive and USB cable
•
Labels for bus numbers
•
Rail kit
•
VT5900-L
•
Power cords
•
Power Cord Strain Relief Kit (clips and documentation)
•
HP Insight Foundation Suite for ProLiant CDs
•
HP ProLiant Firmware Maintenance CD
•
HP Server Adapter Quick Installation Sheet
•
HP ProLiant Server Setup Poster (includes DL380 G6 documentation CD)
•
Rail kit (includes rail installation instructions)
•
HP Virtual TapeServer Base Release 6.04.03 DVD
•
External DVD/CD-ROM drive and USB cable
•
Labels for bus numbers
Virtual TapeServer Quick Setup Guide | 5
Advertisement
Table of Contents
