Installation - Vaillant VR 91f Operating And Installation Instructions

3 For the competent person
3.1.2 Storing documents
▶
Pass these instructions and all other
applicable documents on to the system
operator.
3.1.3 Validity of the instructions
These instructions apply only to:
VR 91f – article number
Great Britain

3.2 Installation

3.2.1 Checking the scope of
delivery
Quant- Contents
ity
1 Remote control unit
1 Fastening material (2 bolts and 2
wall plugs)
4 Batteries, LR06
1 Documentation
3.2.2 Requirements for determining
the reception strength of the
remote control
– The set-up and installation of all system
components and the radio receiver unit
(except for the control and the outdoor
temperature sensor) is complete.
– The power supply for the entire system
is switched on.
– The system components are switched
on.
3.2.3 Installing the remote control
Determining the installation site of
the remote control in the building
1. Choose an installation site that meets
the following requirements.
– Interior wall of the main living room
– Installation height: 1.5 m
– not in direct sunlight
– not affected by heat sources
10
0020231566
Operating and installation instructions 0020253110_01
Determining the reception strength
of the remote control at the chosen
installation site
2. Observe all the points listed in "Re-
quirements for determining the re-
ception strength of the remote control
(→ Page 10)".
3. Stand next to the radio receiver unit.
B
4. Open the remote control's battery com-
partment as shown in the figure.
5. Insert the batteries, making sure that
the poles are the right way round.
◁
The installation assistant starts.
6. Close the battery compartment.
7. Select the language.
8. In ascending order, enter the ad-
dresses in the Remote control
address function.
9. Start with address 1.
10. Press the OK selection button.
◁
The installation assistant starts the
pairing process.
11. Press the pair button on the radio
receiver unit within 10 seconds.
◁
Pairing successful. Control is
being restarted. appears on the
display.
12. Continue pressing the functions that
appear using the OK selection button
A
!