Operating Instructions; Setting Up The Mac For Use; Figure 5 Mac Block Diagram - Federal Signal Corporation MAC-02 Description, Specifications, And Operations Manual

Operating Instructions

Figure 5 MAC Block Diagram

Operating Instructions
The operating instructions consist of three parts:
•
•
•

Setting up the MAC for use

To set up the MAC for use, do the following:
1. Connect antenna to BNC antenna port located on the front of the MAC Radio
2. Connect the USB cable between the computer and the USB port located in the
10
Setting up the MAC for use
Activating sirens using Commander Software
Powering the MAC
Case.
NOTE: RF communications are affected by a number of physical factors; such
as, antenna placement and RF interference. Therefore, the placement of the radio
antenna on high ground typically improves radio commutations. Whereas, the
placement of the radio antenna inside a vehicle can degrade radio commutations.
front the MAC Radio Case.
NOTE: You can use the RS232 port instead of the USB port.
Mobile Activation Case (Models MAC-01 and MAC-02)