All Rights Reserved. No Part Of This Manual May Be Reproduced, In Any Form - Neo-Neon SRM-25007 User Manual

ELC 250WATT MINI NEO-ONE
Neo-Neon International
CHANNEL 6 – SHUTTER / DIMMER
NO.
1
2
3
4
CHANNEL 7 – RESET & LAMP CONTROL
NO.
1
2
3
4
ADDRESS SELECTION
The control address, also known as the start channel, is the first channel
used to receive instructions from the controller. The total number of
channels used depends on the control mode.
Be sure to allow adequate channels when setting the control address.
If control channels for one fixture overlap control channels for another
fixture, then one of the fixtures will receive the wrong commands. To
find the highest usable address channel, subtract the number of channels
required from the last controller channel and add 1. Two Mini Neo
One's of the same type, and operating in the same control mode, may
share the same address if they are to respond identically. They will
receive the same commands and individual control will be impossible.
To set the control address
1.
Scroll to
current address is displayed.
2.
Scroll to the address that is assigned to the fixture on the
controller. Press [enter] to activate the address setting.
12

All rights reserved. No part of this manual may be reproduced, in any form,

Without the express permission, in writing from Neo – Neon LTD GUANGDONG,
DMX VALUE
0 - 15
16 - 127
128 - 239
240 - 255
DMX VALUE
0 – 127
128 – 191
192 – 250
251 – 255
Addr
in the main menu and press [enter]. The
©
Neo Neon LTD, GuangDong china
China
EFFECT
SHUTTER
DIMMING
STROBE (FAST TO SLOW)
OPEN
EFFECT
STRIKE LAMP
REPOSITION AFTER 5 SECS
TURN OFF LAMP
TURN LAMP OFF AFTER 10
SECS
Printed in China 2006