Yaesu VXA-200 Operating Manual page 29

The VXA-200 allows you to scan automatically in
ø1
the VFO , Main Memory, "Book" Memory, or
ø2
Weather Channel modes. It pauses on signals en-
countered, so you can talk to the station(s) on that
frequency, if you like.
ø1: In the VFO mode, the automatic scanner is only
available in the C O M band (118.000 - 136.975
MHz); when the scanner reaches the uppermost fre-
quency in the C O M band, it will revert to the bot-
tom end of the C O M band and repeat the scanning
process until you cancel the scanning process.
ø2: USA version only.
If you wish to scan in the N A V band (108.000 -
117.975 MHz), you can do so manually, as described
at the right.
Scanning operation is basically the same in each of
the above modes.
r Press the [ SCAN ( DW )] key momentarily to start
the automatic scanner upward (toward a higher
frequency or a higher channel number).
r When the scanner encounters a signal, scanning
pauses and the radio remains on that channel until
one second after the signal disappears, after
which scanning will resume.
VXA-200 A P
VIATOR
S
CANNING
II O M
ILOT PERATING
O
PERATION
r While the scanner remains paused on a frequency,
the decimal point of the frequency display blinks.
The display will be illuminated unless the Scan
Lamp Feature is turned off.
r To change the scan direction, turn the CHAN-
NEL selector knob one click in the opposite di-
rection.
r To stop the automatic scanner, press the PTT switch
or the CHANNEL selector knob momentarily. You
may also press [ SCAN ( DW )] key again.
The VXA-200's automatic scanner is not operational
in the N A V band (108.000 - 117.975 MHz), because
the N A V stations (ILS, etc.) transmit constantly
(thereby causing the scanner to stop repeatedly).
However, you can scan manually in the N A V band,
per the following procedure:
r Press and hold the [ SCAN ( DW )] key to start
the manual scanner. Scanning will continue as
long as the key is depressed.
r Release the [ SCAN ( DW )] key to stop the
manual scanner immediately.
Note: When scanning upward in frequency, when the
frequency reaches the C O M Band (118.000 - 136.975
MHz) via manual scanning, The VXA-200 will
switch to the automatic scanner mode.
ANUAL
27