Enjoying Music With The Speaker Lights Turned On; Using An Optional Equipment; Setting The Automatic Standby Function - Sony GTK-XB5 Operating Instruction

Hide thumbs Also See for GTK-XB5:
Table of Contents

Advertisement

Available languages

Available languages

Enjoying music with the
Speaker Lights turned on
1
Press LIGHT.
The Speaker Lights are turned on.
You can also select various light
modes such as the following by
using "SongPal" (page 16).
• RAVE: a light mode suitable
for dance music with a lot of
flashing
• CHILL: a light mode suitable for
relaxing music
• RANDOM FLASH OFF: a light
mode without flash suitable for
all music, including dance music
• HOT: a light mode of warm color
• COOL: a light mode of cool color
• STROBE: a light mode with an
electronic flash of white color
To turn off the Speaker Lights
Press LIGHT again.
Note
If the illumination brightness is glaring,
switch on the room lights or turn off the
illumination.
Using an optional
equipment
1
Connect an optional
equipment (i.e. WALKMAN®,
smartphone, TV, DVD player,
IC recorder, etc.) to the
AUDIO/PARTY CHAIN IN L/R
jacks on the unit using an
audio cord (not supplied).
2
Press FUNCTION
repeatedly until the AUDIO IN
indicator on the unit lights up.
3
Start playback on the
connected equipment.
4
Note
The system may enter standby mode
automatically if the volume level of the
connected equipment is too low. In this
case, increase the volume level of the
equipment. To turn off the automatic
standby function, see "Setting the automatic
standby function" (page 23).
Setting the automatic
standby function
By default, this system is set to turn
off automatically in about 15 minutes
when there is no operation or audio
signal output.
To turn off the function, hold
down  more than 3 seconds
while the system is turned on.
To turn on the function, repeat the
procedure.
You can also configure this setting
and make sure whether this
function is turned on or off by using
"SongPal." For details on "SongPal,"
see "Using "SongPal" via BLUETOOTH"
(page 16).
PAIRING
Adjust the volume.
Adjust the volume of the
connected equipment first. If the
volume level is still too low, adjust
the volume level on the system
using the volume +/– buttons.
23
GB

Advertisement

Table of Contents
loading

Table of Contents