Swim Spa Trouble Shooting Guide - Master Spas Trainer 12 Owner's Manual

SWIM SPA TROUBLE SHOOTING GUIDE

NOTHING ON THE SWIM SPA OPERATES-
1. Check the control panel display for any messages. If there is a message, refer to the diagnostic section
on that model swim spa. There you will find the meaning of the message and what action is to be taken.
2. If there is no message on the control panel, check and reset the GFCI breaker. GFCI breaker will be
located external to the swim spa.
If the swim spa does not respond, contact your local service company.
PUMP(S) DO NOT OPERATE -
1. Press the "Jets" button on your control panel.
If you hear the pumps trying to operate:
A. Check that all the slice valves are open. See photo on page 13.
B. Pump may need to be primed. See page 19.
C. Check that the air controls are open. See photo on page 11.
If you do not hear anything from the pump, contact your local service company.
POOR JET PERFORMANCE
1. Make sure pump is operating
2. Check that the water level is adequate (up to minimum safe water level side)
3. Make sure the jets are open and the air controls are open. See page 11.
4. Check for dirty filters. Clean if necessary.
DO NOT DIVE.
* The swim spa GFCI breaker or disconnect should be located in a
weather proof box close to the swim spa, but no closer then 5 feet.
53