Gnss Toolbox; Gnss Settings; Gnss Status - ashtech MobileMapper 10 Getting Started Manual

GNSS Toolbox

GNSS Settings

GNSS Status

GNSS Toolbox is used to control and monitor important
functions in your receiver. These are listed and detailed
below.
• GNSS Settings: Constellations and frequencies used in the
receiver.
• GNSS Status: Views GNSS reception monitoring screens.
• Reset: Resets the receiver.
• About: Provides the software version of GNSS Toolbox.
• Open the GNSS Toolbox and tap on GNSS Settings. This
opens a new window where you can make the following
settings:
– Tracking mode: Only the "GPS L1" option is available,
which means the receiver can only operate from the L1
signal of the GPS constellation.
– Use SBAS check box: Check this box to enable SBAS
reception, clear it otherwise.
– Elevation mask: Any satellite seen from the receiver with
an elevation angle less than the specified elevation
mask will be rejected. "5 degrees" is the default and
recommended value for this parameter.
• Tap OK to confirm your choices and return to the GNSS
Toolbox window.
• Open the GNSS Toolbox and tap on GNSS Status.
11