Table of Contents
Advertisement
STARTING AND DRIVING
||
NOTE
To reach level I or II without starting the
engine - do not depress the brake pedal, or
the clutch pedal for cars with manual gear
changing, when these ignition positions are to
be selected.
•
Ignition position I - Turn the ignition dial to
START and release it. The control automati-
cally returns to its starting position.
•
Ignition position II - Turn the ignition dial to
START and hold it in the START position for
approx. 4 seconds. Then release the knob,
which automatically returns to its starting
position.
•
Back to ignition position 0 - To return to
ignition position 0 from position I and II -
Turn the ignition dial to STOP and release it.
The control automatically returns to its star-
ting position.
Related information
•
Starting the car (p. 386)
•
Switching off the car (p. 387)
•
Driver display (p. 90)
1
If the car is moving, then you simply need to turn the start knob towards START to start the engine.
386
Starting the car
The car is started using the remote control key
and the start knob in the tunnel console.
Start knob in the tunnel console.
The remote control key is not physically used
when starting the car since the car is equipped
with support for keyless starting (Passive Start).
To start the car:
1. The remote control key must be inside the
car. For cars with Passive Start, the key
needs to be located in the front part of the
passenger compartment. With the keyless
locking/unlocking option (Passive Entry*),
the key can be anywhere in the car.
2. For cars with automatic gear changing, make
sure that gear position P or N is selected.
For cars with manual gear changing, make
sure that the gear lever is in neutral position
and that either the clutch pedal or the brake
pedal is depressed.
3. Depress the brake pedal fully
4. Turn the start knob to START and release it.
The control automatically returns to its star-
ting position.
NOTE
For diesel-engined cars, there may be a slight
delay before starting is initiated.
When the engine is started the starter motor
works until the engine is started or until its over-
heating protection triggers.
Backup reader's location in the tunnel console.
1
.
* Option/accessory.
Advertisement
Table of Contents
