System Tab - Cisco aironet 1810 series User Manual

Configuration Page

System Tab

The Configuration System (see
information.
The Login section allows the user to change the username and password for the access point.
You can leave the username and password fields, along with the router's user name and password fields
Note
blank, to disable access control.
The Radio section allows the user to configure radio interface parameters. You can configure the
parameters for both the 2.4 GHz and the 5 GHz radios. To set these parameters, first click the radio you
want to configure from under the System tab.
You can set the following parameters for each radio:
•
•
•
•
•
Figure 2-4 Configuration–System Tab
Cisco Aironet 1810 Series OfficeExtend Access Point User Guide
2-6
Status—Enable/disable the selected radio interface (i.e. 2.4 GHz or 5 GHz).
802.11ac mode—Enable/disable the 802.11ac mode. This parameter is present only for the 5 GHz
radio.
802.11n mode—Enable/disable the 802.11n mode.
Bandwidth—Select the channel bandwidth. You can choose 20MHz, 40MHz, or 80MHz.
Channel Selection—Select a particular channel to operate in. For automatic selection, choose Auto.
Figure 2-4) tab displays and allows the user to configure general system
Chapter 2 Understanding the Access Point GUI