Configuring Radio Channels On The Access Point - Cisco aironet 1810 series User Manual

Configuring Radio Channels on the Access Point

Click Continue.
Step 7
The 1810 Series OfficeExtend Access point will connect to the controller and download the current
software image. Allow the device 5 minutes to download and reboot with the new code and
configuration.
Configuring Radio Channels on the Access Point
Follow these steps to configure a radio channel for your 1810 Series OfficeExtend access point.
Access the 1810 Series OfficeExtend access point GUI as described in
Step 1
page
Choose Configuration > System.
Step 2
Choose the desired radio interface – either 2.4 GHz or 5 GHz.
Step 3
From the Status drop-down list, choose Enabled to enable the wireless interface.
Step 4
From the Channel Selection drop-down list, choose the channel on which this interface will operate.
Step 5
Note
Click Apply to commit your changes.
Step 6
Configuring Personal Wireless LANs
Access the 1810 Series OfficeExtend access point GUI as described in
Step 1
page
Choose Configuration > SSID.
Step 2
Choose the radio band, which can be either 2.4 GHz or 5.0 GHz. You can duplicate the configuration on
Step 3
both bands, or have different settings on each band.
In the Personal Network section:
Step 4
a.
b.
c.
Note
Cisco Aironet 1810 Series OfficeExtend Access Point User Guide
1-4
2-1.
802.11n mode should be enabled by default. If it is disabled, choose Enabled from the
802.11 n-mode drop-down list.
2-1.
Check the Enabled check box to enable this wireless connection. By default it is disabled.
Check the Broadcast check box to broadcast the SSID over the air. By default it is unchecked.
In the SSID field, enter the personal SSID that you want to assign to this access point. This SSID
will be locally switched.
Your personal SSID Wireless LAN and your company SSID Wireless LAN are different. When
you configure your personal Wireless LAN, use an SSID name that is different from your
company's SSID to help avoid confusion.
Chapter 1 Installing and Configuring the Access Point
"Accessing the GUI" section on
"Accessing the GUI" section on