Oil Pump Priming - Polaris Outlaw Owner's Manual

MAINTENANCE AND LUBRICATION

Oil Pump Priming

This priming procedure must be performed whenever the
oil hose connection between the oil tank and pump inlet
has been disconnected.
1. Clamp or pinch off the vent line (1) approximately
2I (5 cm) from the oil tank.
2. Run the engine for 5-10 seconds at idle. Stop the engine
and remove the vent line clamp. If the line is bled
properly, you should hear a rush of air, indicating that
the line is properly primed and ready for operation. If
you do not hear air, the line has not bled, and you'll
need to repeat the priming procedure.
112
1