Cold Weather Operation - Polaris MV700 Owner's Manual For Maintenance And Safety

OPERATION
Starting the Engine
8. Turn the ignition lever past the ON position to engage the starter.
Activate the starter for a maximum of five seconds, releasing the
lever when the vehicle starts.
9. If the engine does not start, return the ignition lever to the OFF
position and wait five seconds. Activate the starter for another five
seconds if necessary. Repeat this procedure until the engine starts.
NOTE: If a warm engine has cooled to a point where it does not
readily start, intermittent use of the choke button (pulled half
way out) may be necessary. If the engine is over-choked
when warm, depress the throttle lever fully while cranking to
aid in starting. Release the throttle lever immediately after
the engine starts. If the engine does not start and all
conditions are favorable, change the spark plug and try
again.
10. If the engine slows or stops, position the choke knob half way in to
allow proper engine warm-up. Vary the engine RPM slightly with
the throttle to aid in warm-up. When the engine idles smoothly,
push the choke completely in.
CAUTION
Operating the vehicle immediately after starting could cause
engine damage. Allow the engine to warm up for several minutes
before operating the vehicle.

Cold Weather Operation

If the ATV is used year-round, check the oil level frequently. A rising
oil level could indicate the accumulation of contaminants such as water
or excess fuel in the crankcase. Water in the crankcase can lead to
engine damage and must be drained. Water accumulation increases as
outside temperature decreases.
See your Polaris dealer for engine heater kits, which provide quicker
warm-ups and easier starting in colder weather.
48